- #Icom ic 7300 driver for mac install
- #Icom ic 7300 driver for mac software
- #Icom ic 7300 driver for mac Pc
Set “Soundcard Output” for Speaker (USB Audio CODEC). Set “Soundcard Input” for Microphone (USB Audio CODEC).Ģ. Click “Test PTT” again to return to the receive mode.įor the last settings, click the “Audio” tab.ġ. (Note: The IC-7300 just changes to the transmit mode, but no modulated signal is transmitted.Ħ. If the “Test PTT” indicator changes to red, and the IC-7300 starts transmitting, all settings are properly made. Click “Test CAT” in the right bottom corner. Other settings should be the same as shown in the screen above.ĥ. Set the Baud rate for 19200 (or the rate you set in the CI-V screen above.)Ĥ. (The example screen shot shows that COM 6 is selected.)ģ. Select the same COM port as the one you noted in the previous settings. elect “Icom IC-7300” as the Rig setting.Ģ. Next, click the “Radio” tab to enter the settings for the Radio parameters.ġ. However, you must input your own call sign and your grid location instead of the examples shown above. If you are not sure of each setting, just use the same settings shown above for simple operations. Input other parameters, according to your operating environment. Select the “General” tab in “File””Settings””General.” Input your call sign and your grid location.
The setting parameters for the IC-7300 are finished. CI-V Baud Rate: Auto 19200 (or other fixed baud rate) Next, set the CI-V parameters for the standby and frequency controls as follows. ・SET mode External terminal Modulation Input(DATA ON). First, do the following procedures to input the modulation signal from the USB port in the USB DATA mode.
You need to set the IC-7300 for modulation and demodulation through the USB port.
#Icom ic 7300 driver for mac Pc
You will operate in the FT8 mode with your PC through only the USB cable in this issue. This example screen shows that COM port 6 is open. Note the COM port number to also use for the IC-7300 settings. (This cable does not come with the IC-7300.) We recommend that you use a USB cable with ferrite cores attached, to prevent RF feedback.Īfter the USB cable is connected, and the IC-7300 is turned ON, your PC will automatically recognize that the IC-7300 is connected. 1.8.0 is the latest version as of April 2018.Ĭonnect a USB cable between the USB port on the IC-7300 and a USB port on your PC.
#Icom ic 7300 driver for mac install
Next, you need to download the WJST-X software* from the K1JT home page and install it into your PC.
#Icom ic 7300 driver for mac software
Download the latest* USB driver software for the IC-7300 from the Icom web-site and install onto your PC before connecting to the IC-7300. We hope many hams enjoy the FT8 need to install a USB driver software onto your PC before connecting to the IC-7300. Only a USB cable should be used to connect between your IC-7300 and a PC. Our FB News staff will explain that in this issue. FB News readers who read the technical article “Operating the FT8 mode with the IC-7610”, described in the December 2017 issue, asked us to show the settings for the IC-7300.
0 kommentar(er)
